Finder 18.51.8.230.0300 Indoor Motion Detector with push-in terminals

Finder 18.51.8.230.0300 Indoor Motion Detector with push-in terminals

Motion detector suitable for ceiling installation in indoor environments. Equipped with a lens with 360 ° optics capable of homogeneously detecting movement in the coverage area for the automation of the lighting system with absorption up to 10A. Supplied with three different supports which allows for recessed installation, in false ceilings and externally to the ceiling.

• 230 VAC power supply
• 1 NO contact 10 A - 250 V AC
• Shutdown delay from 12 seconds to 35 minutes

Possibility of installation

The detector is supplied with several adapters that allow installation multiple ways. Two masks are supplied for installation in flush-mounted or false-ceiling boxes to be completed with the appropriate plate supplied or it is possible to mount the detector in the center of the room using the special container also supplied.

False ceiling mounting	Flush mounting	External mounting

Push-in terminals for a quick and safe connection of cables

The Push-in system allows fast and reliable wiring of the detector without the need to use tools. This aspect is particularly useful considering the not always easy positioning of the detector which must possibly take place in the center of the room at a distance of about 2.5-3 meters from the floor. The push-in system accepts both rigid and flexible cables, even with ferrules with a section up to 2.5 mmq.

Rigid cable connection or with ferrules	Flexible cable connection	Disconnection

Limiting eyelid

The supplied limiting membrane allows to contain the controlled area in order to reduce the number of unwanted detections in the installation area.

The eyelid is applied mechanically even after installation.

The detection area thus obtained will be approximately 2 meters in case of installation at a typical height of 2.8 meters.

Sensor cover and wiring diagram